This guide refers to the following wheelsets:
- HUNT 30, 40, 50 Carbon Disc Wheelset
- HUNT 35 Carbon Gravel Disc Wheelset
- HUNT 25 Carbon Gravel X-Wide Wheelset
- HUNT 4 Season All Road Disc (2024 - Onwards)
- HUNT 4 Season Gravel Disc (2024 - Onwards)
Need to order the parts featured in this guide? Head to our Spares page here. Our guide to using the Spares Finder is here.
- Remove the wheel from the bike and remove cassette if fitted.
- Pull the drive side end cap from the axle – no tools are required.
- With the freehub body, this simply slides off the axle. The H_Ratchet SGL and silver cylindrical spacer are likely to stay in place within the hub body. Should the H_Ratchet SGL come out, please note the orientation in preparation for re-installing. The cylindrical spacer must stay on the axle to prevent the system binding (when re-installed).
- To service the freehub mechanism, clean the H_Ratchet SGL and ratchet rings of the freehub body with a dry micro-fibre cloth and lubricate with a thin layer of lightweight grease on each surface.
- Ensure the cylindrical spacer is on the axle and then fit the H_Ratchet SGL onto the drive side of the axle, with the sprung side facing outwards. Then slide the freehub of your choice on. You may have to turn the H_Ratchet SGL a little to slide into the ratchet ring teeth.
- Push the adaptor/end cap back on to the drive side of the axle.
Please Note: if swapping from SRAM XD or SHIMANO HG to SHIMANO Microspline or vice versa the drive side end cap is specific to the freehub body. - Ensure that the adaptors/end caps are fully pressed home to ensure proper fit and prevent any lateral play.
Please Note: Remove the elastic band before fitting your cassette