Changing an H_RATCHET DBL Freehub Body
THIS GUIDE REFERS TO THE FOLLOWING WHEELSETS:
- HUNT 42 Limitless Gravel Adventure Wheelset
- HUNT SUB50 Limitless Aero Disc Wheelset
- HUNT SUB50 Limitless UD Carbon Spoke Disc Wheelset
- HUNT Gravel Race Disc Wheelset (2024)
- HUNT Hill Climb SL Disc Tubular Wheelset
- HUNT 4 Season Pro Disc Wheelset
- Remove the wheel from the bike and remove cassette if fitted.
- Pull the drive side end cap from the axle – no tools are required.
With the freehub body, this simply slides off the axle. The H_Ratchet DBL is likely to stay in place within the hub body. Should it come out, please note the orientation in preparation for re-installing.
To service the freehub mechanism, clean the H_Ratchet DBL and ratchet rings of the freehub body with a dry micro-fibre cloth and lubricate with a thin layer of lightweight grease on each surface.
Fit the H_Ratchet DBL onto the drive side of the axle, with the sprung side facing outwards. Then slide the freehub of your choice on. You may have to turn the H_Ratchet DBL a little to slide into the ratchet ring teeth.
Push the adaptor/end cap back on to the drive side of the axle. Please Note: if swapping from SRAM XD or SHIMANO HG to SHIMANO Microspline or vice versa the drive side end cap is specific to the freehub body.
- Ensure that the adaptors/end caps are fully pressed home to ensure proper fit and prevent any lateral play.
Did you find it helpful?
Yes
No
Send feedback Sorry we couldn't be helpful. Help us improve this article with your feedback.